NetComm 3G38WV-TS User Manual page 39

WPS
WPS is the simplest way to establish a connection between wireless clients and your NetComm Smart Hub 4G. This method
removes the need to manually select the encryption mode and fill in the passphrase. You only need to press a button on both the
wireless client and the NetComm Smart Hub 4G router, and the WPS feature will complete the wireless connection. The NetComm
Smart Hub 4G supports two types of WPS:
OPTION
A specific button needs to be pressed on the wireless client or in the wireless client utility to start WPS mode. Then
WPS via Push Button switch the NetComm Smart Hub 4G to WPS mode either by pushing the WPS button on the wireless router, or by
clicking the 'Apply' button in the web configuration interface.
A PIN code needs to be assigned to the wireless client set to WPS mode. Then to complete the wireless connection
WPS via PIN code
input the wireless client PIN into the NetComm Smart Hub 4G web interface.
Use the drop box to either enable or disable the WPS function.
OPTION
Status:
SSID:
WPS Auth Mode:
WPS PIN:
WPS Mode:
NetComm Smart Hub 4G User Guide
39
Table 23 - Advanced View - Enable or Disable WPS
Figure 44 - Advanced View - WPS Settings - Disabled
Figure 45 - Advanced View - WPS Settings - Enabled
If the wireless security (encryption) function of this wireless router is properly set, you will see a 'Success' message
here. Otherwise, you will see a message in the WPS Status field stating 'Idle'.
This is the network broadcast name (SSID) of the router.
This field shows the active authentication mode for the wireless connection.
This is the WPS PIN code of the wireless router. You may need this information when connecting to other WPS
enabled wireless devices.
Select either PIN mode or PBC (which is the WPA via Push Button).
Table 24 - Advanced View - WPS Settings
DEFINITION
DEFINITION
YML38
www.netcommlimited.com