NetComm 3G38WV-TS User Manual page 32

Router Advertisement
PPPoE relay
DNS Proxy
Click 'Apply' to save the settings.
Advanced Routing
This page allows you to configure static and dynamic routing rules for your NetComm Smart Hub 4G.
Advanced Routing – Static
Static Routing allows computers that are connected to your NetComm Smart Hub 4G to communicate with computers on another
LAN segment which are connected to it via another router. To set a rule, you need to specify the following:
 Destination
 Range – Select from Host (255.255.255.255) or Net (and then enter the appropriate subnet mask)
 Gateway
 Interface
 Comment to identify the route entered (optional)
Advanced Routing – Dynamic
Dynamic Routing uses the RIP protocol to allow the NetComm Smart Hub 4G to adapt to changes in the network. RIP enables the
device to determine the best route for each packet based on the "hop count" or number of hops between Source and Destination.
To enable Dynamic Routing, select Enable from the drop box and click Apply.
YML38
www.netcommlimited.com
device to be automatically identified by other UPnP devices. Select "Disable" to disable this
option.
The default option is "Disable". Select "Enable" to enable it.
The default option is "Disable". Select "Enable" to enable it.
The default option is "Disable". Select "Enable" to enable it.
Table 19 - Advanced View - LAN Settings
Figure 35 - Advanced View - Advanced Routing Settings
3G38WV-TS
Telus 3G38WV-TS User Guide
32