First Time Simple Configuration Wizard - NetComm 3G38WV-TS User Manual

First Time Simple Configuration Wizard

When you log in to your NetComm Smart Hub 4G for the first time, you will be presented with the NetComm Smart Hub 4G "Set-up
Wizard" as shown in the screenshot below. This wizard can be skipped by clicking on the link shown on the screenshot below. You
can re-run the Setup Wizard again anytime after first use by selecting the "Startup Wizard" option under the "Administration" tab in
the Advanced View of the management console.
Select your Language Preference, Time Zone and whether you would like to activate the System Monitor feature and then click
"Next" to continue;
Please note: The System Monitor feature will regularly check the internet connection. If the specified failure count is
exceeded, the device will reset the MBB connection. You can also choose a Periodic Reboot interval to force the NetComm
Smart Hub 4G to reboot after the specified period of time. For more information on this and System Monitor configuration
options, please refer to the System Monitor configuration section on page 46.
This page allows you to customize the username and password required to administer your NetComm Smart Hub 4G. It is
recommended that you choose a unique password for added security. Please enter the username and password that you wish to
use, or leave these fields unchanged to use the default username and password of admin. Click "Next" to continue.
NetComm Smart Hub 4G User Guide
11
Figure 3 - Startup Wizard Language, Time Zone and System Monitor Settings
Figure 4 - Startup Wizard - Web Configuration Username and Password Settings
YML38
www.netcommlimited.com