Charging The Ktm Powerpack In The Storage Charging Mode - KTM Freeride E-XC 2019 Owner's Manual

Hide thumbs Also See for Freeride E-XC 2019:
Table of Contents

Advertisement

17.7

Charging the KTM PowerPack in the Storage charging mode

Note
Material damage The power supply will be damaged in the event of an overload.
In the Storage charging mode, a steady current of at least 10 A is required.
Ensure that the mains connection can supply the steady current required and is protected by a suitable fuse.
Note
Environmental hazard A lithium-ion battery (KTM PowerPack) contains components and elements that are
harmful to the environment.
Never throw a KTM PowerPack into the household trash.
Dispose of the KTM PowerPack properly and in compliance with the applicable regulations. (Your
authorized KTM workshop will be glad to help.)
Info
The charge level of the KTM PowerPack must be below 50% before the Storage charging mode can be
used.
If the temperature of the KTM PowerPack exceeds the permissible value while it is being charged, the bat-
tery charger stops charging. All LEDs and the LEDS for the current charging level alternately light up every
second.
After the temperature of the KTM PowerPack returns to the permissible range, charging is resumed auto-
matically.
KTM POWERPACK, BATTERY CHARGER 17
LED 3: 60 %
LED 4: 80 %
LED 5 flashes beginning with approx. 95% until 100% is
reached.
Once the charging process is complete, all five LEDs light up
and the status indicator goes out.
Switch off the battery charger using switch
After several seconds, all LEDs on the battery charger go
out.
Disconnect the battery charger power plug from the mains con-
nection.
Disconnect the charging cable from the KTM PowerPack.
Guideline
Pull on the structured part of the connector. Do not pull on
C00769-11
the cable.
Check the seal on the charging socket protection cap.
»
If the seal is dirty:
Clean the seal without using water or compressed air.
»
If the seal is damaged or worn:
Change the seal.
Mount the charging socket protection cap.
Finishing work
Lock the seat. (
Preparatory work
Position the battery charger. (
4
.
p. 69)
p. 109)
113

Advertisement

Table of Contents
loading

Table of Contents