12
SERVICE WORK ON THE CHASSIS
12.15
Adjusting the steering head bearing play
12.16
Lubricating the steering head bearing
12.17
Removing the front fender
Preparatory work
–
Raise the motorcycle with the lift stand. (
Main work
–
Loosen screws
–
Remove screw
–
Loosen and retighten screw
Guideline
Screw, top steering head
–
Using a plastic hammer, tap lightly on the upper triple clamp to avoid stresses.
–
Tighten screws
E00397-10
Guideline
Screw, top triple clamp
–
Mount and tighten screw
Guideline
Screw, top steering stem
Finishing work
–
Check the play of the steering head bearing. (
–
Remove the motorcycle from the lift stand. (
(EXC‑F EU/AU)
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
(EXC‑F Six Days)
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
800010-10
Preparatory work
–
Remove the headlight mask with the headlight. (
Main work
(EXC‑F EU/AU)
–
Remove screws
V00340-10
–
Remove screws
V00341-10
(EXC‑F Six Days)
.
.
.
.
.
M8
(
(
.
. Remove the front fender.
p. 52)
M20x1.5
12 Nm (8.9 lbf ft)
M8
17 Nm
(12.5 lbf ft)
17 Nm
Loctite
(12.5 lbf ft)
p. 60)
p. 52)
(
p. 55)
p. 56)
(
p. 56)
p. 58)
p. 97)
61
®
243™