GarrettCom Magnum 6K32T Installation And User Manual page 37

Magnum 6K32 & 6K32T Managed Switch
Step 2. Remove Chassis Cover
The Magnum 6K32T chassis are combined with top, bottom and front panel
parts and assembled together with the help of 17 Philips-head screws. There are
5 screws located on the front-bottom and 3 at rear-top of the unit and one each
on the front and rear sides. First Remove the front panel screws (total 12) as
shown in the fig 3.5.1a. Once these are removed, the front panel can be easily
pulled out to the front. The top cover can be easily pulled off to the front from
the chassis base, as shown in the Fig. 3.4.1b. When the chassis top cover has
been removed, the interior of the unit is exposed.
Figure 3.5.1a: Removing front panel after the screws being removed
Fig 3.5.1b: Pulling out the top coved from the chassis base
Caution: Be careful not to disturb the power supply.
www GarrettCom com . .
Installation and User Guide (12/05)
31