GarrettCom Magnum 6K32T Installation And User Manual page 16

Magnum 6K32 & 6K32T Managed Switch
2.2.2 Eight-port SFF fiber modules (6K8-MTRJ, 6K8-MLC), 100Mb fiber
1
ACT
F/H
ACT
F/H
LK
ACT
F/H
ACT
LK
F/H
2
In an eight-port SFF fiber port module, all of the fiber ports are of the same
speed (100Mb), mode, and connector type. Models that are available with Small Form
Factor (SFF) are multi-mode MT-RJ or LC-type connectors, and single-mode LC-type
connectors.
The 100Mb fiber eight-
port modules for the Magnum
6K32T normally are set (factory
default) to operate in full-duplex
mode for best fiber distance and
performance. Using the 6K32T's
MNS software, the user may select full- or half-duplex mode per-port through the set-up
of the software (See the Magnum 6K32T MNS Software Manual for the flexibility to
adapt to any FDX or HDX type of Fast Ethernet devices).
There are three LED's per fiber port. The Link (LK) LED indicates "ready for
operation" on that port when lit, the F/H LED indicates operation in full-duplex mode
when ON (half-duplex when OFF), and the blinking ACT LED indicates receiving
Activity on the port. A fiber cable must be connected into a SFF port and the Link (LK)
indicator for that port must be ON (indicating there is a powered-up device at the other
end of the cable) in order for a LK LED to provide valid indications of operating
conditions on that port.
www GarrettCom com . .
3 5 7
LK LK LK
LK LK LK
4 6 8
Installation and User Guide (12/05)
ACT
F/H
ACT
F/H
ACT
F/H
ACT
F/H
1 3
AC
F/H
AC
LK LK
F/H
2 4
AC
F/H
AC
LK LK
F/H
2 4
10
Fig.2.2.2 :
SFF Fiber Port Modules,
6K8-MTRJ (to the left)
and
6K8-MLC or -SLC
(below)
5 7
ACT
F/H
ACT
F/H
LK L
6 8
ACT
F/H
ACT
F/H
LK L
6 8