Advertisement
Installation Instructions
[] INSTALL WATER LINE CLAMP
• Attach the water llne clamp (strain
relief) (8) from
the kit to the refrigerator.
With the clamp directly
in line with the water valve, drive the screw (7)
from the kit through
the clamp(8)
at the indent
into the back of the cabinet.
• The metal clamp
is for the house water line (see
Water Line Installation
Instructions).
It is not to
be used for the tubing
from the water valve up to
the icemaker.
[]CONNECT
THE WATER LINE
• Make
sure
there
is enough
plasdc
water
line
to
extend
from
the
water
valve
to well
into
the
water
tube
inlet
(15).
Cut off any excess
tubing.
• Squeeze
the
ends
of the hose
clamp
(3) from
the
kit with
pliers
and
slide
the
clamp
over
the water
tube
inlet.
• While still squeezing
the clamp,
insert the
plasdc water line into the inlet as far as it will
go (approximately
1" [25 mm]).
• Then slide the clamp
downward
to capture
the
plastic water line in place.
• Make sure the fill tube is aimed
down.
Water tube
[]
ROUTE AND ATTACH
THE
PLASTIC WATER LINE
• Route
the plastic water line along the back of
the refrigerator
to the water tube inlet.
• Fasten
the plastic water llne to the back of the
cabinet
with three of the adhesive-backed
fasteners
(5).
Adhesive-backed
fastenersforplastic
)waterline
I_ WATER VALVE INSTALLED
Refer to the Water Line Installation
Instructions
for connection
to the home water supply. After
water line installatlon
is completed,
set the
icemaker
power switch to I (on).
The icemaking cycle will not begin until the icemaker
and freezer compartment
reach operating temperature,
then icemaking will be_n automatically.
57
Advertisement
