Download Print this page

GE GBS2OKB Owner's Manual And Installation Instructions page 3

Icemaker accessory kit

Advertisement

Installation Instructions
BEFORE YOU BEGIN
Read each step thoroughly
before proceeding.
• CAUTION
-
Unplug
the
_--
Refrigerator.
To eliminate
the danger
_)_
of electric
shock during
installafion,
_
[.._j
you must unplug
the refrigerator
from
\\
its electrical
oudet.
TOOLS YOU WILL NEED
FlatbladeandPhillips
Pliers
screwdrivers
Sharpknife
[] PREPARE FOR INSTALLATION
• Remove
the storage
basket
(on some models)
by pulling
it out to the
stop position
and lifting
it up and out.
Note: After removing
the basket, push the
extension
arms back
into the freezer
compartment.
• Remove
the chiller shelf
(on some models)
by
pulling it straight out.
• Remove the ice bucket
by pulling it out and
lifdng it up and out.
• Remove the center
vertical shelf support
(on some models)
by
lifting it and rotating
its bottom
to the right.
[] PREPARE FOR INSTALLATION (cont.)
• Inside the freezer,
remove
the two small white
plug buttons
(on some models)
from the side
wall. (If screws are present
instead
of plugs,
leave them in place.)
• Remove
and discard
the large white plug
from the rear freezer
wall. Pull out the gray
insulation
plug and
remove
any debris.
• Remove the outlet
plug button
cover with a flat-blade
screwdriver.
Remove side wall plug
Insulation
I_t_s or leave screws
plug
inplace
[] INSTALL
FILL TUBE
• Slide the fill tube shipped
with the refrigerator
onto the
water tube inlet (10). If the fill
tube has been misplaced,
call
1.800.626.2002
and order part
WR02X11712.
• Go to the back of the refrigerator.
Remove the label covering the
hole. Pull out the insulation
plug
and any debris.
• On the tube side of the water
tube inlet (10), there is an
adhesive backing.
Remove the
adhesive backing and slide the
tube into the hole at the back
of the refrigerator.
Firmly press
on the inlet to secure it to the
refrigerator.
[]SET
POWER SWITCH
TO O (off)
Set the icemaker
power switch to O (off). Leave
the power switch in the O (off) position
until the
refrigerator
is connected
to the water supply to
prevent
premature
operation.
3

Advertisement

loading