Advertisement
Installation
Instructions
[]CONNECT
THE WATER LINE
• Make sure there is enough
plastic water line to
extend from
the water valve to well into the
water tube inlet (15). Cut off any excess tubing.
• Squeeze
the ends of the hose clamp (3) from the
kit with pliers and slide the clamp over the water
tube inlet.
• While still squeezing
the clamp,
insert the plastic
water line into the inlet as far as it will go
(approximately
1" [25 mm]).
• Then slide the clamp downward
to capture
the
plastic water line in place.
• Make sure the fill tube is aimed down.
Water tube
inlet-.,.,..,.,.,.]__(_
[_WATER VALVE INSTALLED
Refer to the Water
Line Installation
Instructions
for
connection
to the home water supply. After water
line installation
is completed,
set the icemaker
power switch to I (on).
The icemaking cycle will not begin until the icemaker
a_ freezercomparnnent reachoperatingtemperatu_,
then icemaking will begin automatical_.
[] ROUTE AND ATTACH THE
PLASTIC WATER LINE
• Fasten the plastic water line to the hack of the
cabinet with adhesive-backed fasteners (5),
spacing the fasteners as shown to take up slack
in the line.
I_
Adhesi_-backed fasteners
for plasticwaterline
45
Advertisement
