Download Print this page
   

Advertisement

www.GEAppliances.com
IMPORTANT:
These
instructions are needed to
install an icemaker in your
refrigerator. To be used
with an IM4, IM4A or IM6
Icemaker Kit. Keep this
addendum with your
Owner's Manual and
Installation Instructions.
Installation Instructions
Addendum
These instructions
are to be used to
install an Icemaker
Kit in the models
listed below.
GBS20KBP
GBS22HBP
GBS22KBP
PDS20MBP
PDS20SBP
PDS22MBP
PDS22SBP
197D5736P001
49-60286-3 06-03 JR

Advertisement

   Also See for GE IM4A - G.E. Electronic Icemaker

   Related Manuals for GE IM4A - G.E. Electronic Icemaker

   Summary of Contents for GE IM4A - G.E. Electronic Icemaker

  • Page 1

    www.GEAppliances.com IMPORTANT: These Installation Instructions Addendum instructions are needed to install an icemaker in your These instructions refrigerator. To be used are to be used to with an IM4, IM4A or IM6 install an Icemaker Icemaker Kit. Keep this Kit in the models addendum with your listed below.

  • Page 2: Installation Instructions

    Installation Instructions NEEDED CONTENTS OF KIT The following are a list of the parts from the kit that will be needed to install the icemaker. Hex-Head Screw Phillips Head Screws, for Water Line Clamp for mounting icemaker (2) Icemaker Water Line Clamp Water Tube Inlet (strain relief), for house water line...

  • Page 3: Before You Begin

    Installation Instructions PREPARE FOR INSTALLATION (cont.) BEFORE YOU BEGIN • Inside the freezer, remove the two small white Read each step thoroughly before proceeding. plug buttons (on some models) from the side wall. (If screws are present instead of plugs, CAUTION –...

  • Page 4

    Installation Instructions INSTALL THE MOUNTING SCREWS MOUNT THE ICEMAKER • Lift the icemaker so the fill tube shipped with the • Skip to Step 5 if screws are already in place in refrigerator fits in the fill cup opening (E). Hang the freezer side wall.

  • Page 5

    Installation Instructions WATER VALVE ASSEMBLY INSTALLATION INSTRUCTIONS ATTACH THE WATER VALVE BEFORE YOU BEGIN • Locate the female connector plug (C). Read each step thoroughly before proceeding. CAUTION – • Unplug the Refrigerator. To eliminate the danger of electric shock during installation, you must unplug the refrigerator from its electrical outlet.

  • Page 6

    Installation Instructions ROUTE AND ATTACH THE ATTACH THE WATER VALVE (cont.) WATER TUBE • Clip the end of the ground wire to the refrigerator cabinet. • Fasten the plastic water tube to the back of the refrigerator with three of the adhesive-backed fasteners (4), spacing the fasteners as shown.

  • Page 7

    Notes...

  • Page 8

    Printed in Mexico...

Comments to this Manuals

Symbols: 0
Latest comments: