Advertisement
Installation Instructions
ICEMAKER INSTALLATION INSTRUCTIONS
[]
Are these
the right instructions
for your model?
Follow
the Installation
Instructions
indicated
by
the label on the back of the refrigerator--
[]
[]
[]
[] []
[]
[] []
[]
[] []
[] or []
BEFORE YOU BEGIN
Read each step thoroughly
before
proceeding.
° C_UTION-
Unplug the
_
Refrigerator.
To eliminate
the danger
of electric
shock during installation,
you must unplug the refrigerator
from its electrical
outlet.
TOOLS YOU WILL NEED
Flatblade andPhillips
Pliers
screwdrivers
Sharpknife
[] PREPARE FOR INSTALLATION
• Remove the upper outlet cover with a flat-blade
screwdriver.
• If there is already an icemaker bracket (28) installed in
the freezer, remove the two screws holding on the cover.
Remove and discard the cover. Go to Step 5.
121REMOVE FILL HOLE PLUG
• Remove and discard the large white plug from the
rear freezer wall. Pull out the gray insulation plug
and remove any debris.
Remov,I
plug
[]INSTALL
FILL TUBE
• Slide the instdated
fill tube (23)
ontotho.t et,l`5),
making sltre that the open side
of the fill tube faces up.
• Go to the back of the
refrigerator.
On the tube side
of the water tube inlet (1,5) there is an adhesive
backing.
Remove the adhesive
backing
and slide
the tube into the hole near the top at the back of
the refrigerator.
Firmly press on the inlet to secure
it to the refrigerator.
[] INSTALL
MOUNTING
BRACKET
• Remove the three small plug buttons
on the rear
wall of the freezer and replace
them with three
screws (29) supplied
with the icemaker
kit. Do
not screw them all the way in. The screws should
extend
approximately
1/4" (6 mm) out from
the freezer wall.
_x
• Install the ieemaker
_t
N_
bracket
(28) by hanging
_t,,,i['_N.___-
it from the three screws
that were just installed.
Tighten
the three screws
securely.
©
[] SET POWER SWITCH
TO 0 (off)
Set the icemaker
power switch to 0 (off). Leave
the power switch in the 0 (off) position until the
refrigerator
is connected
to the water supply to
prevent premature operadon.
Hole for
.
wiretie
Power
S_tch
30
Advertisement
