Advertisement
Installation Instructions
WATER VALVE ASSEMBLY INSTALLATION INSTRUCTIONS []
Are these
the right instructions
for your model?
Follow
the Installation
Instructions
indicated
by
the
label
on the
back
of the
refrigerator--
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
or []
BEFORE YOU BEGIN
Read each step thoroughly
before
proceeding.
"C_kUTION-
Unplug the
_
Refrigerator.
To eliminate
the danger
IJ_)
of electric
shock during
installation,
you must unplug
the refrigerator
from its electrical
oudet.
TOOLS YOU WILL NEED
FlatbladeandPhillips
Pliers
screwdrivers
Sharpknife
1/4" Nutdriver
I_REMOVE
THE COVER
At the bottom
rear of the refrigerator,
remove
the
screw(s)
holding
the compressor
compartment
cover (if covered)
and save for reinstallation
later.
Bend the cover back for access to the compartment.
[] ATTACH THE WATER VALVE
• Locate the female connector plug (C) which is
attached to the cabinet by a metal or plasdc clip.
Remove the clip by removing the screw. Save the
screw for moundng the water valve later. Discard
the clip.
Metal or
plastic clip
• Plug the female comtector (C) onto the male
terminals on the water valve (4). Either wire
can go on either terminal.
• Fasten the water valve to the cabinet edge hole
using the hex-head
screw that you removed at
the beginning
of Step 2.
DO NOT DRILL ANY ADDITIONAL
HOLES.
• Check the plastic water line nut on the bottom of
the water valve to be sure it is hand tight.
DO NOT USE TOOLS.
16
Advertisement
