Advertisement
Installation Instructions
[] INSTALL WATER LINE CLAMP
• Attach the metal water line damp
(strain
relief)
(8) to the refrigerator.
Drive the screw (7) from
the kit through
the damp
(8) at the indent
into
the back of the cabinet.
• The metal clamp
is for the house water line (see
the Water Line Installation
Instructions).
It is not
to be used for the tubing
from the water valve up
to the icemaker.
[] ATTACH THE PLASTIC WATER
LINE
Fasten the plastic water line to the back of the
cabinet
with adhesive-backed
fasteners
(5),
spacing the fasteners
as shown
to take up the
slack in the line.
/k
-..,,
Adhesive-backed
fasteners
for
plastic w ater l ine
[_]CONNECT
THE WATER LINE
• Squeeze
the ends of the hose clamp (3) or(6) from
the kit with pliers and slide the clamp over the
water tube inlet. (Use the black clamp (3) with
the black fill tube inlet, use the otber clamp
(6)
with the other
fill tube inlet.)
• While still squeezing
the clamp, insert the
plastic water line into the inlet as far as it will
go (approximately
1" [25 mm]).
• Then
slide the clamp downward
to capture
the
plastic water line in place.
• Make sure the fill tube is aimed down.
Watertube
inlet
I-6q WATER VALVE INSTALLED
Refer to the Water Line Installation
Instructions
for connection
to the home water supply. After
water line installation
is completed,
set the
icemaker
power switch to I (on).
The icemaking cycle will not begin until the icemaker
aml freezer compartment
reach operating temperature,
then icemaking will begin
automaticat_.
21
Advertisement
