Advertisement
Installation Instructions
[] INSTALL WATER LINE CLAMP
• Push the metal water line damp
(strain relief)
(12)
onto the lower flange of the cabinet
back, directly
in line with the water valve.
• The metal clamp is for the house water line. (See
the Water Line Installation
Instructions).
It is not
to be used for the tubing from the water valve up
to the icemaker.
[] AI-rACH THE PLASTIC WATER LINE
Fasten the plastic water llne to the back of the cabinet
with adhesive-backed
fasteners
(5), spacing
the
fasteners as shown m take up the slack in the line.
!
Adhesive-backed
fasteners f orplastic waterline
[] ROUTE THE PLASTIC WATER LINE
On models
that have condenser
tubing
on the back
of the cabinet,
insert the plastic water line between
the tubing
and the back of the cabinet.
Condenser
tubing
[] WATER VALVE INSTALLED
Refer to the Water
Line Installation
Instructions
foJ
connection
to the home water supply. After water
line installation
is completed,
set the ieemaker
power switch to I (on).
The icemaking cycle will not begin until the icemaker
and freezer compartment
reach operating temperature,
then icemaking will begin automatically.
[]CONNECT
THE WATER LINE
• Remove the small plastic cap (B) from the bottom
of the water tube inlet located in the upper-right
rear corner of the refrigerator.
• Squeeze the ends of the hose clamp (6) from the
kit with pliers and slide the clamp over the water
tube inlet.
• While still squeezing
the clamp, insert the
plastic water line into the inlet as far as it will
go (approximately
1" [25 ram]).
• Then slide the clamp
downward
to capture
the
plastic water line in place.
• Make sure the fill tube is aimed down.
Water t ube
inlet
13
Advertisement
