Advertisement
Installation Instructions
ICEMAKER INSTALLATION INSTRUCTIONS []
Are these the right instructions
for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator--
[] [] [] [] [] [] [] [] [] [] [] [] or []
BEFORE YOU BEGIN
Read each step thoroughly
before
proceeding.
° CtAUTION-
Unplug the
_
Refrigerator.
To eliminate
the danger
of electric
shock during
installation,
you must unplug
the refrigerator
from its electrical
outlet.
TOOLS YOU WILL NEED
FiatbladeandPhillips
Pliers
screwdrivers
Sharpknife
[] PREPARE FOR INSTALLATION
• Remove
and discard the large white plug from
the rear freezer
wall. Pull out the gray insulation
plug and remove
any debris.
O
• Remove the two small white plug buttons
on the side
wall. Install two Phillips bead screws (14) in the holes
that the plug buttons
were in, but do not screw them
all the way in. The screw heads should extend about
1/2" (13 mm) from the side wall of the freezer.
• Remove the outlet cover with a flat-blade
screwdriver.
*o
\
[] INSTALL FILL TUBE
• Cut the f'dl tube (16) to the []
length
(refer to the n_ template
(_lllD
Q_
on page 66) with a sharp
knife
or a single-edge
razor blade.
• Slide the fill tube (16) onto the
water tube inlet (15).
• Go to the back of the refrigerator.
In the upper
right hand
comer, remove
the label covering the
hole. Pull out the insulation
plug and any debris.
• On the tube side of the
water tube inlet (15) there
is an adhesive backing.
Remove the adhesive
backing
and slide the
tube into the hole near
[] SET POWER SWITCH TO O (off}
Set the icemaker power switch to 0 (off). Leave
the power switch in the 0 (oflO position
until the
refrigerator
is connected
to the water supply to
prevent
premature
operation,
w_retie
Powr
Switch
46
Advertisement
