Advertisement
Installation Instructions
ICEMAKER INSTALLATION INSTRUCTIONS
[]
Are these
the right instructions
for your model?
Follow
the Installation
Instructions
indicated
by
the label
on the back of the refrigerator--
[]
[]
[] []
[] []
[]
[] []
[]
[]
[] or []
BEFORE YOU BEGIN
Read each step thoroughly
before proceeding.
° Cd_kUTION-
Unplug the
_
Refrigerator.
To eliminate
the danger
i_
of electric
shock during
installation,
you must unplug
the refrigerator
from its electrical
outlet.
TOOLS YOU WILL NEED
Flatblade andPhillips
Pliers
screwdrivers
Sharp knife
[] PREPARE FOR INSTALLATION
• Remove
and discard the large white plug or foil
sticker
from the rear freezer
wall. Pull out the
gray insulation
plug and remove
any debris.
• Loosen
the two mounting
screws but do not
screw them
all the way out. The screws should
extend
approximately
1/2"
(13 ram) out from
the freezer
wall.
• Remove the outlet cover with a flat-blade
screwdriver.
*o
[] INSTALL FILL TUBE
• Cut the fill tube (16) to the []
length
(refer to the [_]
(_1_
_
template
on page 66) with a
sharp knife or a single-edge
razor blade.
• Slide the fill tube (16) onto the water tube inlet (15).
• Go to the back of the refrigerator.
In the upper
right hand comer, remove
the label covering the
hole. Pull out the insulation plug and any debris.
• On the tube side of the
water tube inlet (15) there
is an adhesive backing.
Remove the adhesive
backing and slide the tube
into the hole near the top at
the back of the refrigerator.
Firmly press on the
inlet to secure it to the refrigerator.
[] SET POWER SWITCH
TO 0 (off)
Set the icemaker
power switch to 0 (off). Leave
the power switch in the 0 (off) position until the
refrigerator
is connected
to the water supply to
prevent
premature
operation.
j_.
/
Hole for
Switch
5O
Advertisement
