Setting Up Motion Detection - HIKVISION DS-7200HVI-ST Series User Manual

1. Enter the PTZ Configuration m
Configuration.
2. Select the On C Camera Settin
3. Select a Patrol l Number to se
4. Select a Preset t Number that i
patrol.
5. Click the Add b button. The Pre
6. Repeat steps 4- -5 until you hav
7. Click the Up an nd Down button
8. To test out you ur new preset, c
9. Click the Done e button to exit
7.5 C Configu uring A
7.5.1 S Setting Up p Motion
Set up pro operly, using mo otion detected r
relevant ev vents rather tha an everything, w
To set up motion detectio on:
1. Enter th he Motion Dete ection Settings m
Detection Settings.
2. Select t the camera to co onfigure in the
with the sa ame settings,se lect All Camera
3. Check t the Enable Mo otion Detection
disable mo otion detection. .
4. Set the motion detectio on sensitivity by
the higher r the sensitivity willbe to motio
5. Set the motion detectio on region in the
area. A re d grid will besh hown, designati
on areas th hat overlap the current selected
Screen bu utton to include the whole area
section fro om the motion d detection region
6. If you'r re not satisfied w with the selecte
7. Select t the Actions to t take if motion is
available i includes:
menu, shown in n Figure 42 by g
ngs tab.
et from the drop p down list.
is next to the P atrol Number
eset Number w will be added to
ve included all t the presets you
n at the bottom of the list to ch
lick the Play bu utton. The PTZ
out of the PTZ Configuration
Alarms s and E
Detection n
recording will i increase the num
which willalso m make searching
menu, shown in n Figure 45 by g
Figure 45. M Motion Detectio
camera drop do own menu on th
as from the list. .
n checkbox to en nable motion de
y adjusting the green Sensitivi
on.
e preview screen n on the right s
ing that the sele ected area is par
dmotion detecti ion area will in
into the motion n detection regi
n.
ed region, you m may click the C
s detected in th e designated re
going to MainM Menu > System
from the dropd down list that yo
the patrol list.
would like to h haveon the patro
hange the order ofthe presets in
should moveth hrough the list o
menu.
Excepti ions
mber of days yo ourDVR is able
g for events easi ier.
going toMain M Menu > Recordi
on Settings Men nu
he upperleft of t the menu. If all
etection forthe selected camera
ity bar. Themor re lime green re
ide of themenu u by left-clicking
rt of the motion n detectionregio
clude them into o the region. Yo
ion.Left-clickin ng on any part o
Clear buttonto re eset the motion
gions. Moretha an one action ca
Configuration > PTZ
ou would like to o add to the
ol.
n the patrol.
of added presets s.
e to record. It w will only record
ing Configurati on > Motion
l cameras are to o be configured
a. Uncheck the checkbox to
ectangles select ted in the bar,
g with the mou se on an open
on. Dragging or r left-clicking
ou may also clic ck theFull
of the grid will r remove that
detection area.
an be selected. T The actions
43 3