7.3.1 Configuring Basic PTZ Settings
Settings for a PTZ camera must be configured before it can be used. Before proceeding,verify that the PTZ and RS-485 of the
DVR are connected properly.
To configure PTZ settings:
1.
Enter the PTZ Configuration menu, shown in Figure 42 by going to MainMenu > System Configuration > PTZ
Configuration.
2.
Select the Serial Settings tab.
3.
Select the camera to configure in the camera drop down menu on the upperleft of the menu. If all cameras are to be
configured with the same settings,select All Cameras from the list.
4.
Configure PTZ settings, including those of Baud Rate, Data Bit, Stop Bit, Parity,Flow Ctrl, Protocol and Address
according to the parameters of the PTZcamera(s).
5.
Click the Save button to save current settings.
To test and verify PTZ settings:
1.
Enter the PTZ Configuration menu, shown in Figure 41 by going to MainMenu > System Configuration > PTZ
Configuration.
2.
Select the On Camera Settings tab. This will open up the On Camera Settingsmenu, shown in Figure 43.
Figure 42. PTZ Configuration Menu
Figure 43. PTZ Configuration
41