Configuring Osd Settings - HIKVISION DS-7200HVI-ST Series User Manual

2. Select the camera to setup video loss detection in using the camera drop downmenu on the upper left of the menu. If all
cameras are to be configured withthe same settings, select All Cameras from the list.
3. Click Enable Video Loss Detection.
4. Select Actions to take if video loss is detected. More than one action can beselected per channel. These actions include:
•
Sound Audio Warning: DVR will sound an audio warning if video loss isdetected.
•
Pop-up Image on Monitor: DVR will show the corresponding channelthat is associated with the video loss
channel.
•
Notify Surveillance Center: DVR will notify surveillance center whenvideo loss is detected.
•
Send Email: DVR will send an email out to the designated recipients whenvideo loss is detected.
•
Trigger Alarm Output: DVR will trigger alarm output when video loss isdetected. Selecting this option will
enable the Alarm Output list, where theoutput to trigger can be selected.
5. Select the Save button to save the privacy zones settings and select Exit toreturn to the previous menu. Selecting the
Exit button without clicking Savewill quit out of the menu without saving settings.
8.4 Configuring OSD Settings
On Screen Display (OSD) settings can be configured in the OSD Configuration menu. TheOSD is shown in each display in Live
Feed and Playback mode.
To configure OSD settings:
1. Enter the OSD Configuration menu, shown in Figure 53 by going to MainMenu > Cameras Setup > OSD
Configuration.
Figure 52. Video Loss Detection Menu
49