Using A Usb Mouse - HIKVISION DS-7200HVI-ST Series User Manual

The keys on the remote control closely resemble the ones found on the front panel.Referring to Figure 6, they include:
1. POWER Button: Same as POWER button on front panel .
2. DEV Button: Enables/Disables Remote Control.
3. Alphanumeric Buttons: Same as Alphanumeric buttons on front panel .
4. EDIT Button: Same as EDIT/IRIS+ button on front panel .
5. A Button: Same as A/FOCUS+ button on front panel.
6. REC Button: Same as REC/SHOT button on front panel .
7. PLAY Button: Same as PLAY/AUTO button on front panel .
8. INFO Button: Same as ZOOM+ button on front panel .
9. VOIP Button: Same as MAIN/SPOT/ZOOM‐ button on front panel .
10. MENU Button: Same as MENU/WIPER button on front panel .
11. PREV Button: Same as PREV/FOCUS‐ button on front panel .
12. DIRECTION/ENTER Buttons: Same as DIRECTION/ENTER buttons onfront panel .
13. PTZ Button: Same as PTZ/IRIS‐ button on front panel .
14. ESC Button: Same as ESC button on front panel .
15. RESERVED: Reserved.
16. F1 Button: Same as F1/LIGHT button on front panel .
17. PTZ CONTROL Buttons: Buttons to adjust the iris, focus and zoom of a PTZcamera.
18. F2 Button: Same as F2/AUX button on front panel .
Aim the remote control at the IR receiver located at the front of the unit to test operation. Ifthere is no response:
1. Using the front control panel or the mouse, go into Main Menu > System Configuration>Display Configuration
2. Check and remember DVR device No. The default ID# is 255. This ID# isvalid for all IR controls.
3. Press the DEV button on the remote.
4. Enter the DVR ID# from step 2.
5. Press the ENTER button on the remote.
If the Status indicator on the front panel turns blue, the remote control is operatingproperly. If the Status indicator does
not turn blue and there is still no response from theremote, please check the following:
1. Batteries are installed correctly and the polarities of the batteries are notreversed.
2. Batteries are fresh and not out of charge.
3. IR receiver is not obstructed.
Note:
If buttons are not available on front panel, they are also unable on remote control
1.5 Using a USB Mouse
A regular 3‐button (Left/Right/Scroll‐wheel) USB mouse can also be used with this DVR.
To use a USB mouse:
1. Plug USB mouse into one of the USB ports on the front panel of the DVR.
2. The mouse should automatically be detected. If in a rare case that the mouse isnot detected, please refer to the
recommended device list from your provider.
The buttons on the mouse corresponds to:
1. Left Button:
Single-Click: Select a component of a menu, such as a button or an inputfield. This is similar to pressing the
•
ENTER button on the remote/frontpanel controls.
Double-Click: Switch between single screen and multi‐screen mode inPreview/Playback mode.
•
Click and Drag: Clicking and dragging the Left mouse button can be usedto control the pan/tilt of a PTZ camera
•
as well as to vary the amount of digitalzoom. It can also be used to setup the alarm areas.
2. Right Button:
Single-Click: Shows pop‐up menu.
•
3. Scroll-Wheel:
Scroll Up: In Preview mode, scrolling up will switch to the previousscreen. In Menu mode, it will move the
•
selection to the previous item.
Scroll Down: In Preview mode, scrolling down will switch to the nextscreen. In Menu mode, it will move the
•
selection to the next item.
.
14