Adjustable Cutting Guide Alignment - MK Diamond Products MK-170 Owner's Manual

MK-170 Tile Saw
(D)
Verify cooling flow on both
sides of the blade (adjust flow if
necessary - See Maintenance
Section)

adjustable Cutting Guide alignment

If during the cutting operation it is found that Adjustable Cutting is not aligned to the Blade, perform
the following operation.
(A)
Loosen the Adjustable Cutting
Guide Alignment Screws
(E)
Push the Tile into the Blade in a
smooth even motion to perform
a cut
(B)
Gently align the Adjustable Cut-
ting Guide to the Blade
19
OPeRaTiON
(F)
Turn the motor OFF when work
is complete
(C)
Tighten the Adjustable Cutting
Guide Alignment Screws