Blade Dressing - MK Diamond Products HD-101R Pro24 Owner's Manual

HD-101R Pro24
(J)
Lubricate the Cutting Head
Adjustment Knob.

BlaDe DReSSinG

A diamond blade performs best when it is dressed. Over time and use, diamonds on the outer
edge of the blade will become smoothed or "glazed" over. This will reduce grinding efficiency and
may cause the blade to "wander" or bend giving the illusion of an alignment problem. When this oc-
curs, the blade will need to be dressed. The diamond blade can be dressed using the MK Dressing
Stick (part number 152792) and by following the steps below.
(A)
Setup the MK101 for operation
(See Setup, Adjustment
and Operation).
DiaMonD BlaDe CHanGe-oUT
noTe: When installing the Retaining Nut, do not "cross-thread" and DO NOT over tighten
the retaining nut.
(A)
Locate the Shaft Lock push-
button on the underside of the
Cutting Head.
(K)
Lubricate the Cutting Head
Adjustment Knob retaining
holes.
(B)
Set the Adjustable Cutting
Guide to cut a 1/16-strip.
(B)
Remove Retaining Nut and Outer
Flange, depress and hold the Shaft
Lock pushbutton and loosen.
38
MainTenanCe
(L)
Lubricate the Cutting Head
Pivot Shaft.
(C)
Position the Dressing Stick. Cut
2 or 3 strips from the dressing
stick to dress the Blade.
(C)
Remove the Diamond Blade.