Output Cabling; Computer Video - Extron electronics TP Receivers Family User Manual

b
Composite video input connector — Attach one end of a TP
cable to this RJ-45 female connector. Attach the other end to an
Extron TP video transmitter outputting composite video. See
Termination of TP cable on page 2-17 for pin assignments.

Output cabling

Computer video

The TP R BNC A, TP R BNC AV, and TP R 15HD A receive and
output RGB video. These receivers can also receive component
(bi-level sync only) video, S-video, or composite video and
output them on the R, G, and B signal lines.
Reception of bi-level component video, S-video, or composite
video requires an internal jumper (TP R BNC AV and TP R BNC)
or external DIP switch (TP R 15HD A) be repositioned. See
"Video jumpers" or "Video DIP switch" earlier in this chapter.
c
RGB Output BNCs (TP R BNC A and TP R BNC AV) —
Connect the desired video output device to the rear panel
output BNCs:
For RGBHV video, use the R, G, B, H/HV, and V BNCs.
R
For RGBS video, use the R, G, B, and H/HV BNCs.
R
For RGsB or component video, use the R (R-Y), G (Y), and B
(B-Y) BNCs.
R
For S-video, use the R (C-chroma) and G (Y-luma) BNCs.
R
For composite video, use the R, or G, or B BNC.
R
-or-
N
TP Receivers • Installation and Operation
G B H/HV
G B H/HV
G B H/HV
G B H/HV
G B H/HV
-or-
The H/HV and V BNCs output sync, not video signals.
V
V
V
V
V
2-13