Rear Panel HDMI Audio Switch
The XTP SFR HD 4K has an HDMI audio switch that mutes or unmutes the embedded
audio on the HDMI output connector (see
switch lights when HDMI audio is enabled.
Move and hold the rear panel HDMI audio switch up for about 1 second to enable
embedded audio on the associated HDMI connector, or move and hold the HDMI audio
switch down for about 1 second to disable embedded audio on the associated HDMI
connector. The switch returns to the middle position after it has been released.
Audio Output Overview
By default, an XTP transmitter or matrix switcher prioritizes embedded digital audio over
analog audio. Use SIS commands (see
XTP System Configuration Software (see
page 28) to manually select the audio input.
Audio Input Format
LPCM
Multi-channel PCM
Dolby Digital 2/0
Dolby Digital 2/0 Surround
Dolby Digital 5.1
Dolby Digital EX
Dolby Digital Plus
Dolby TrueHD
DTS 2-channel
DTS Digital Surround 5.1
DTS-ES Matrix 6.1
DTS-ES Discrete 6.1
DTS-HD
DTS-HD Master Audio
On-Screen Display Menu System
XTP SFR HD 4K Configuration and adjustments can be performed by using SIS commands
(see
(see
controls and the OSD menu. The OSD menu is used primarily when the receiver is first set
up.
NOTE: The OSD menu has a fixed time-out of 10 seconds.
SIS Configuration and Control
XTP System Configuration Software
figure
2,
D
on page 5). The LED next to the
SIS Configuration and Control
XTP System Configuration Software
Audio Output LEDs
HDMI
S/PDIF
X
X
X
X
X
X
X
X
X
X
X
X
X
X
on page 19), the XTP System Configuration Software
on page 28), or by using the front panel
XTP SFR HD 4K Scaling Fiber Receiver • Operation
on page 19) or the
on
Analog
X
X
X
X
X
X
X
X
X
X
11