Xtp Interconnection; Output Connections - Extron electronics XTP SFR HD 4K User Manual

XTP Interconnection

XTP input connector
A
pair cable transmitter or matrix switcher (see
Recommendations for XTP Communication
connector. This cable carries the following signals:
Digital video
•
• Digital audio
• Bidirectional RS-232 and IR commands
Signal LED indicator — Lights green when the XTP SR HD 4K receives an
active XTP input signal from a compatible transmitter or matrix switcher.
Link LED indicator — Lights yellow when a valid XTP link is established.
ATTENTION:
•
•
•
•
B LAN connector
10/100Base-T Ethernet communication through this
pass-through connector. LEDs on the connector indicate link and activity status.
C RS-232 Over XTP port
XTP-compatible devices, connect a control device to the 5-pole captive screw
connector. The connector includes only the two poles labeled "RS-232" and shares the
ground pole with the IR poles.
IR Over XTP port
control device to the 5-pole captive screw connector. This connector includes only the
two poles labeled "IR" and shares the ground pole with the RS-232 poles.
NOTE: RS-232 and IR data can be transmitted simultaneously (see
Over XTP Communication

Output Connections

D HDMI output connector and audio switch
female HDMI connector. To mute or unmute the embedded audio, hold the HDMI audio
switch up or down (see
(with an appropriate adapter) signals.
NOTES:
•
•
(see figure 2 on the previous page) — Connect an XTP twisted
Do not connect this connector to a computer data or telecommunications
network.
Ne connectez pas cet connecteur à un réseau de télécommunications ou de
données informatiques.
XTP remote power is intended for indoor use only. No part of the network that
uses XTP remote power should be routed outdoors (see
page 14).
XTP à distance est destiné à une utilisation en intérieur seulement. Aucune
partie du réseau qui utilise l'alimentation XTP à distance ne peut être routée en
extérieur (voir Remote power
— Connect a control or controlled device to the receiver for
— To pass bidirectional serial or other control signals between
— To transmit and receive IR signals (up to 56 kHz), connect a
HDMI Audio Switch
The maximum cable length is 15 feet (4.6 meters).
Use an Extron LockIt Cable Lacing Bracket to secure the HDMI connector to
the device (see HDMI Connection
Twisted Pair Cable Termination and
on page 9) to the RJ-45 XTP input
Remote power
•
• Ethernet communication
• System communication
à la page 14).
on page 11 for wiring details).
— Connect a digital video display to the
on page 16). It supports HDMI or DVI
on page 8).
XTP SR HD 4K Scaling Receiver • Installation
Signal Link
Remote power on
RS-232 and IR
6