Change User Name - Sanav MU-201 User Manual

Change User Name

Generally, SMS command execution needs correct user name with password, or it will remain the same setting.
The SMS command default user name is "username". It can be changed by following the command format.
For example, entering the SMS command as the following allows user to change the user name from "username" to a new
user name "jacky".
Only enter new command with new user name after it has been changed.
Setup Format: #「username」,「Password」,「Function Mode」,「New User Name」*
Command: #username,0000,1,jacky*
SMS/ COTA Command
#
user name
0000
1
jacky
*
Situation
Setup Succeeds
Setup Fail
Emergency Mode
8
MU-201 GPS/GPRS Nano Tracker User Manual
Description
Start sign.
Default ID of the device.
 Default password.
 If you have changed the password, please use the updated one.
Mode 1 defines user name setup mode.
 New user name changed by the user.
 At the maximum of 16 characters, including a~z,A~Z,0~9, @ - _ / .!%&
 Please notice that you should notice if the letters is capitalized or in small
letters when sending the command.
End sign.
Table: User Name Change Format Description
Message Reply
<OK>Username setup,V4.231;100%
<FAIL>Username setup,V4.231;100%
<FAIL>PANIC ON; Command not Allow!,V4.200;100%
Table: User Name Change Response Description
Copyright © 2011 San Jose Technology, Inc. All Rights Reserved.