Command Setup For Mu-201 - Sanav MU-201 User Manual

Command Setup for MU-201

MU-201 currently provides SMS command and COTA (TCP) command for remote setup. User can setup the MU-201 by
following the instructions shown in following chapters via SMS/COTA. Key the specific SMS message in your cellular phone
and send it to the SIM number of MU-201. The setup messages are showed in the following sections.
1: The default setting:
Default ID is "username". Please read chapter Change User Name to desired ID.
Default password is "0000". Please read chapter Change Password to change the password.
There is no number in the default contact. Please read chapter Set up Phone Book List to add the number.
Default setting of Auto Report is deactivated. Please read chapter Set up Auto Report by Time to setup the regular
auto report.
Default setting of APN is only suitable for Taiwan GSM network. Please read chapter Set up APN for GPRS Service to
change the APN.
Default setting of URL is http://www.sanavtw.com/uploadM1.php. Please read chapter Set up URL to change the
URL for http server setup.
Before doing any setup, please ensure the device is connected with the GSM network. The GSM LED must light on. And
please note the device is not in SOS/Panic mode.
2: Please note that all the characters which include #, * and comma (,) should be HALFWIDTH form.
3: Please be aware of the upper (capital)/lower cases when entering the SMS command.
4: While entering any SMS command, note that NO SPACE is allowed between the characters, comma and signs in the
SMS.
5: Any setup command must be started with a "#" sign and ended up with a "*" sign.
6: The comma (,) can be abbreviated if no further setup required for the command besides Set up APN for GPRS
Service. Please refer to the examples of Set up Auto Report.
6: Add or not add the "+ "sign in front of the cellular phone number(s) are both acceptable, while the"+" sign should
precede the international call prefixes. The specified international call prefix is required if "+ "sign is not added.
7: The device will update setting Only when the password, username and setup command are all correct.
If the command is not valid, a failure report is going to be sent to the user's cell phone.
8: Some PREPAID PHONE CARD SIM modules do not enable or even support GPRS service. Please consult with GSM
carrier for further information.
7
MU-201 GPS/GPRS Nano Tracker User Manual
Copyright © 2011 San Jose Technology, Inc. All Rights Reserved.