Set Up Auto Report - Sanav MU-201 User Manual

Set up Auto Report

Generally, the device will generate GPS (GPRMC) data and report to server, specified cellular phone or network routes.
Auto Report setup can enable the device report GPS data automatically during a period of time.
Use this command to set up the frequency of Auto Report. The device can report according to time interval. If you send
the SMS command as the following example, the device will send a report every 5 minutes (300 seconds) and the total
number of reports is 99.
Setup Format: #「User Name」,「Password」,「Function Mode」,「Intervals (sec.)」,「Total number of reports」,,, [Time
Unit(s/m/h)]*
Example1:#username,0000,6,300,99*
Example2:#username,0000,6,300,99,,,s*
Note: The report times of Auto Reports can be set by entering the digits from 1 to 9998 in the「total number of reports」
field. When 9999 is entered, the device will generate unlimited Auto Reports, when 0 is entered, the device will
stop/disable Auto Report.
SMS/ COTA Command
#
username
0000
6
300
99
s
*
Situation
Setup Succeeds
Emergency Mode
24
MU-201 GPS/GPRS Nano Tracker User Manual
Description
Start sign.
 Default user name of the device.
 If you have changed the username, please use the updated one.
 Default password.
 If you have changed the password, please use the updated one.
Mode 6 defines Auto Report setup mode.
Time Interval (period) of Auto Report.
Times (frequency) of Auto Reports that will be sent automatically.
Time Unit as "s" for seconds (default), "m" for minutes, and "h" for hours.
In this example, we put "300" in constant interval of sending data and blank for the Time
Unit, so the actual report will be 300 seconds.
End sign.
Table: Auto Report Setup Format Description
Message Reply
<OK>Auto setup,V3.793;56%
<FAIL>PANIC ON; Command not Allow!,V4.091;98%
Table: Auto Report Setup Response Description
Copyright © 2011 San Jose Technology, Inc. All Rights Reserved.