Vibration Sensitivity - Sanav MU-201 User Manual

Vibration Sensitivity

User can define the sensitivity of Vibration by setting the following SMS/COTA command. There are 3 steps to define the
sensitivity from most sensitive to least sensitive.
Setup Format: #「username」,「Password」,「Function Mode」,「on/off」,「show/hide」,「write」,「Sensitivity」, 「Stop
Detection Buffer Time」*
Command: #username,0000,vs,on,show,write,1,180*
SMS/ COTA Command
#
username
0000
vs
on
show
write
1
180
*
Situation
Setup Succeeds
Emergency Mode
39
MU-201 GPS/GPRS Nano Tracker User Manual
Description
Start sign.
Default ID of the device.
If you have changed the user name, please use the updated one.
Default password.
If you have changed the password, please use the updated one.
Mode 'vs' defines Vibration setup mode.
on Enable the vibration.
off Disable the vibration.
show Enable Vibration Status events report.
hide Disable Vibration Status events report.
The write command for sensitivity setting.
Sensitivity Level:
1 Most vibration sensitivity
2 Less vibration sensitivity
3 Least vibration sensitivity
To define if the device stops for how long will be counted as "stop". There are
60/120/180/240/300 second steps setting.
End sign.
Table: Vibration Sensitivity Setup Format Description
Message Reply
<OK>VS Write;VS SHOW,V3.937;76%
<FAIL>PANIC ON; Command not Allow!, V3.937;76%
Table: Vibration Sensitivity Setup Response Description
Copyright © 2011 San Jose Technology, Inc. All Rights Reserved.