The Ipv6 Screen - ZyXEL Communications GS1900 Series User Manual

The following table describes the labels in this screen.
Table 54 Configuration > System > IP > IPv4
LABEL
IPv4 Address
Mode
IP Address
Subnet Mask
Gateway
DNS Server 1
DNS Server 2
Management
VLAN
Apply
Cancel

17.2.2 The IPv6 Screen

Use this screen to view the IPv6 interface status and Switch's management IPv6 addresses.
Click Configuration > System > IP > IPv6 to open this screen.
Figure 72 Configuration > System > IP > IPv6
The following table describes the labels in this screen.
Table 55 Configuration > System > IP > IPv6
LABEL
IPv6 Address
DHCPv6 Client
Auto
Configuration
GS1900 Series User's Guide
DESCRIPTION
Select Static to define the IPv4 network properties or DHCP to allow the device to define
the properties.
Enter the IP address of the Switch in the IP domain.
Enter the subnet mask of the Switch in the IP domain.
Enter the IP address of the default outgoing gateway in dotted decimal notation, for
example 192.168.1.254.
Enter the IP address for the primary domain name server. DNS (Domain Name System) is
for mapping a domain name to its corresponding IP address and vice versa.
Enter the IP address for the secondary domain name server. DNS (Domain Name System)
is for mapping a domain name to its corresponding IP address and vice versa.
Enter the port number of the management VLAN.
Click Apply to save the changes.
Click Cancel to discard the changes.
DESCRIPTION
Select Enable to allow the device to act as a DHCPv6 client or Disable to disallow it. This
field displays the Switch's DHCP settings when it is acting as a DHCPv6 client.
Select Enable to allow the device to auto-configure the IPv6 properties or Disable to
manually enter the properties.
Chapter 17 Configuration: System
91