The Vlan Screen - ZyXEL Communications GS1900 Series User Manual

Chapter 24 Configuration: Multicast
Table 98 Configuration > Multicast > IGMP (continued)
LABEL
Snooping
Version
Unknown
Multicast Action
Apply
Cancel

24.2.2 The VLAN Screen

Use this screen to view the IGMP VLAN settings. Click Configuration > Multicast > IGMP >
VLAN to open this screen.
Figure 117 Configuration > Multicast > IGMP > VLAN
The following table describes the labels in this screen.
Table 99 Configuration > Multicast > IGMP > VLAN
LABEL
IGMP VLAN
Edit
VLAN ID
Status
Router Ports
Auto Learn
Query
Retry
Interval (sec)
Max. Response
Interval (sec)
Last Member Query
Count
Interval (sec)
Querier
136
DESCRIPTION
Select v2 or v3 depending on the snooping version you require.
Select to send the IPv4 unknown multicast frame to the router port. The following options
are available:
• Flood - select to send the frame(s) to all ports.
• Drop - select to discard the frame(s).
• Router Port - select to send the frame to router port.
Click Apply to save the changes.
Click Cancel to discard the changes.
DESCRIPTION
Click Edit to change the properties of the IGMP VLAN entry.
Displays the ID of a static VLAN; the valid range is between 1 and 4094.
Display the status of the VLAN as enabled or disabled.
Displays the Switch learn multicast router port member status of any VLANs as enabled or
disabled.
Displays the number of query retry times.
Displays the amount of time (in seconds) between general query messages sent by the
router connected to the upstream port.
Displays the amount of time (in seconds) the router connected to the upstream port waits
for a response to an IGMP general query message.
Displays the number of queries.
Displays the amount of time (in milliseconds) between the IGMP group-specific queries sent
by an upstream port when an IGMP Done message is received.
GS1900 Series User's Guide