Figure 182 Configuration > Management > SNMP > Trap
The following table describes the labels in this screen.
Table 164 Configuration > Management > SNMP > Trap
LABEL
SNMP Trap
SNMP Authfailure
Trap State
SNMP LinkupDown
Trap State
SNMP Warm-Start
Trap State
SNMP Cold-Start
Trap State
Apply
Cancel
30.3.9 The Trap Destination Screen
Use this screen to view the Trap Destination settings. Click Configuration > Management >
SNMP > Trap Destination to open this screen.
Figure 183 Configuration > Management > SNMP > Trap Destination
GS1900 Series User's Guide
DESCRIPTION
Select the SNMP entity is permitted to generate authentication failure traps. Possible
modes are:
•
Enabled: Enable SNMP trap authentication failure.
•
Disabled: Disable SNMP trap authentication failure.
Select the SNMP trap link-up and link-down mode operation. Possible modes are:
•
Enabled: Enable SNMP trap link-up and link-down mode operation.
•
Disabled: Disable SNMP trap link-up and link-down mode operation.
Reboot using software or hardware button reboot.
Reboot though power off.
Click Apply to save the changes.
Click Cancel to discard the changes.
Chapter 30 Configuration: Management
199