The Lag Port Screen - ZyXEL Communications GS1900 Series User Manual

Chapter 21 Configuration: Link Aggregation
The following table describes the labels in this screen.
Table 89 Configuration > Link Aggregation > LAG Management > Add
LABEL
LAG Management
LAG
Name
Type
Member Ports
Apply
Cancel

21.2.4 The LAG Port Screen

Use this screen to view LAG port settings. Click Configuration > Link Aggregation > LAG Port
to open this screen.
Figure 108 Configuration > Link Aggregation > LAG Port
The following table describes the labels in this screen.
Table 90 Configuration > Link Aggregation > LAG Port
LABEL
LAG Port
Edit
LAG
Name
Port Type
State
Speed
Duplex
FlowCtrl State
FlowCtrl Status
126
DESCRIPTION
Select the link aggregation group (LAG).
Enter the name of this entry.
Select Static or LACP.
Select the member ports to be part of the LAG.
Click Apply to save the changes.
Click Cancel to discard the changes.
DESCRIPTION
Select this check box to configure the properties of a port. Click the Edit button change the
properties of the port.
Displays the LAG index value.
Displays the LAG name.
Displays the port type.
Displays the state as Enable/Disable.
Displays the speed value as Auto, Auto-10M, Auto-100M, Auto-1000M, Auto-10/
100M, 10M, 100M, or 1000M.
Displays the duplex value as Full, Half, or Auto.
Displays whether flow control is Enable/Disable.
Displays whether flow control is in use (Enable) or not (Disable).
GS1900 Series User's Guide