The Lag Management Screen - ZyXEL Communications GS1900 Series User Manual

Chapter 21 Configuration: Link Aggregation
Figure 105 Configuration > Link Aggregation > Global
The following table describes the labels in this screen.
Table 87 Configuration > Link Aggregation > Global
LABEL
Global
LACP State
LACP System
Priority
Load Balance
Algorithm
Apply
Cancel

21.2.2 The LAG Management Screen

Use this screen to view LAG management settings. Click Configuration > Link Aggregation >
LAG Management to open this screen.
Figure 106 Configuration > Link Aggregation > LAG Management
124
DESCRIPTION
Select Enable to activate the link aggregation control protocol.
LACP system priority is a number between 1 and 65,535. The switch with the lowest system
priority (and lowest port number if system priority is the same) becomes the LACP "server".
The LACP "server" controls the operation of LACP setup. Enter a number to set the priority
of an active port using Link Aggregation Control Protocol (LACP). The smaller the number,
the higher the priority level.
Select the outgoing traffic distribution type. Packets from the same source and/or to the
same destination are sent over the same link within the trunk. By default, the Switch uses
the src-dst-IP + src-dst-mac distribution type. If the Switch is behind a router, the
packet's destination or source MAC address will be changed. In this case, set the Switch to
distribute traffic based on its IP address to make sure port trunking can work properly.
Select src-dst-mac to distribute traffic based on a combination of the packet's source and
destination MAC addresses.
Select src-dst-ip + src-dst-mac to distribute traffic based on a combination of the
packet's source and destination IP addresses.
Click Apply to save the changes.
Click Cancel to discard the changes.
GS1900 Series User's Guide