Bandwidth Management; Bandwidth Control - ZyXEL Communications GS1900 Series User Manual

Chapter 7 Monitor: Port
Table 26 Monitor > Port > PoE
LABEL
Allocated Power(W)
Remaining
Power(W)

7.4 Bandwidth Management

This section shows you the maximum bandwidth using the Bandwidth Management screen.
Bandwidth management shows themaximum allowable bandwidth for incoming and/or out-going
traffic flows on a port.

7.4.1 Bandwidth Control

Use this screen to view the Switch's bandwidth control in egress global burst and port rate.
An egress port is an outgoing port, that is, a port through which a data packet leaves for both ports.
An ingress port is an incoming port, that is, a port through which a data packet enters.
Click Monitor > Port > Bandwidth Management > Bandwidth Control to access this screen.
Figure 38 Monitor > Port > Bandwidth Management > Bandwidth Control
Each field is described in the following table.
Table 27 Monitor > Port > Bandwidth Management > Bandwidth Control
LABEL
Egress Global Burst
Egress Global
Burst
Port Rate
Port
56
DESCRIPTION
This field displays the total amount of power the Switch has reserved for PoE after
negotiating with the connected PoE device(s).
Consuming Power (W) can be less than or equal but not more than the Allocated
Power (W).
This field displays the amount of power the Switch can still provide for PoE.
Note: The Switch must have at least 16 W of remaining power in order to supply power
to a PoE device, even if the PoE device needs less than 16 W.
DESCRIPTION
This field specifies the current egress burst size in bytes all ports.
View the maximum bandwidth allowed in kilobits per second (Kbps) for the traffic flow
on a port.
This field displays the port number.
GS1900 Series User's Guide