Table of Contents
Advertisement
Chapter 5 EP Management
The following table describes the items in this screen.
Table 15 EP Management > Ether > Config > IGMP (termination system)
LABEL
IGMP Snooping
Apply
Back
5.5.5 The VLAN Screen
Use this screen to configure VLAN tagging on the termination system's interfaces. Click EP
Management > Ether > Config > VLAN on the local termination system device and then select
Enable from Tag VLAN to show the following screen.
Figure 17 EP Management > Ether > Config > VLAN (termination system)
The following table describes the items in this screen.
Table 16 EP Management > Ether > Config > VLAN (termination system)
LABEL
Cascade Mode
Tag V LAN
Port
Priority
VID
In Rule
Out Rule
Apply
Back
28
DESCRIPTION
Select Enable to enable IGMP v1/2 fast leave. Select Disable if only IGMP v3 is
implemented on the network.
Click Apply to save your settings.
Click Back to return to the previous screen.
DESCRIPTION
Select Enable to enable VLAN tagging.
This shows the port name for this row.
Select the 802.1Q priority applied to incoming frames.
Select the 802.1Q VLAN ID applied to incoming frames.
Select Accept All to forward all incoming frames regardless of VID. Select VID Matched to
forward only the incoming frames that match the port VID.
Select Tag to add an 802.1Q tag to egress frames. Select Untag to remove the 802.1Q tag
from egress frames. Select Bypass to leave the tag of the frame alone.
Click Apply to save your settings.
Click Back to return to the previous screen.
EOC350 Series User's Guide
Advertisement
Table of Contents
