1000/100/10 Lamp; Hard Disk Drive Lamp - NEC Express 5800/120Eh N8100 SERIES User Manual

1000/100/10 Lamp

The 1000/100/10 lamp indicates whether each of the network ports normally equipped with the
server is operated through the 1000BASE-T, 100BASE-TX or 10BASE-T network interface. If the
lamp is lit orange, the network port is operated through 1000BASE-T. If the lamp is lit green, the
network port is operated through 100BASE-TX. If the lamp is off, the network port is operated
through 10BASE-T.
100/10 Lamp
The 100/10 indicates whether the management LAN port is operated through the 100BASE-TX or
10BASE-T network interface. If the lamp is lit green, the network port is operated through
100BASE-TX. If the lamp is off, the network port is operated through 10BASE-T.

Hard Disk Drive Lamp

The optional hot-swap SCSI hard disk drive bay can contain four 1-inch height hard disk drives.
Each hard disk drive has a DISK lamp on its front panel.
The DISK lamp indicates the drive status as follows.
Lighting green
The hard disk drive is installed and powered on.
Blinking green
Indicates that the hard disk drive is accessed.
Lighting amber
Indicates that the installed hard disk drive is defected.
NOTE:
(RAID1 or RAID5), a single failed hard disk drive does not affect the
operation of the server. However, it is recommended to replace the
failed hard disk drive and auto-rebuild (reconfigure) the hard disk
drives as soon as possible. (You can hot-swap such a failed hard disk
drive.)
DISK lamp
While hard disk drives are in the disk array configuration
Troubleshooting 8-5