Mounting Into The Classic Rack - Fujitsu Siemens Computers PRIMERGY TX150 Operating Manual

Installing/Removing the Rack Model
Ê Mount the DataCenter Rack cable management (articulated cable guide) as
described in the Technical Manual of the DataCenter Rack.
Ê Mount the server (see section "Installing the Server" on page 44).
Ê Route the cables with the inserted server as described in the Technical
Manual of the DataCenter Rack.
4.4.3

Mounting into the Classic Rack

For mounting the server in the Classic (19-inch) Rack the following parts are
necessary:
– two telescopic rails (assembled)
– protective hose for fibre channel optical waveguide cable
I
General information are provided in the Technical Manual for the Classic
(19-inch) Rack (see also "Related Publications" on page 87).
Ê Refer to the assembly instructions in the Technical Manual for the Classic
(19-inch) Rack (see "Related Publications" on page 87).
Ê Using the mounting aid (stencil) mark the position of the attachment points
for the telescopic rails and for the server (front panel) on the support uprights
(five height units).
Refer to the information on the mounting aid.
Ê Place the spring nuts to fasten the telescopic rails in the groove of the
support uprights at the marked attachment points.
Ê Adjust the position of the nuts in the groove until they lock into the correct
position.
38
Hardware Installation
A26361-K879-Z102-3-7619