Table of Contents
Advertisement
Hot-plug Power Supply Units
8.1.1
Replacing the Hot-plug Power Supply Unit
Figure 31: Unlocking and removing the power supply unit
V
CAUTION!
Before replacing a non defective hot-plug power supply unit in a non-
redundant configuration (only one power supply unit present) the server
must be switched OFF.
Ê Remove the cable from the installed power supply unit.
Ê Push the locking bar of the installed power supply unit towards the power
plug (1).
Ê Hold the bar firmly and pull the power supply unit out of the location in the
direction marked (2).
Ê Push the locking bar of the power supply unit that has to be installed towards
the power plug and hold it in this position.
Ê Insert the power supply unit into the free location.
Ê Lock the power supply unit with the bar such that it engages firmly in the
groove of the mounting frame.
74
Hot-plug/Hot-swap Components
A26361-K879-Z102-3-7619
Advertisement
Table of Contents
