Fujitsu Siemens Computers PRIMERGY TX150 Operating Manual page 56

Connecting the Server to the Line Voltage
Figure 24: Connecting the server to the line voltage
Ê Connect the insulated connector of the power cable to power supply unit of
the server (1), and the power plug to a grounded mains outlet (2) of the in-
house mains and/or into the mains socket strip of the rack (see Technical
Manual of the rack).
I
A phase redundancy in the power supply of the server can be set up if
two hot plug power supply units are installed.
In this case each of the power supply units are directly connected either
to two different phases or to two different power circuits of the in-house
mains.
50
Hardware Installation
A26361-K879-Z102-3-7619