Table of Contents
Advertisement
Hardware Installation
4.4.2
Mounting into the DataCenter Rack
For mounting the server in the DataCenter Rack the following parts are
necessary:
– support bracket
– two telescopic rails (assembled)
– assembly bracket HL (HL is panched onto the bracket)
– two plugwashers (figure 8 on page 33)
I
General information are provided in the Technical Manual for the
DataCenter Rack (see also "Related Publications" on page 87).
Figure 10: Prepare the left telescopic rail
Ê Fasten the delivered assembly bracket HL on the rear end of the left
telescopic rail (1) with two screws M5x8 (2) and two hexagonal flange nuts
M5 (3) as shown in figure 10.
When mounting the left telescopic rail in the DataCenter Rack, the supplied
support bracket must first be mounted level with the device on the rear left
support upright.
A26361-K879-Z102-3-7619
Installing/Removing the Rack Model
35
Advertisement
Table of Contents
