Fujitsu Siemens Computers PRIMERGY TX150 Operating Manual page 40

Installing/Removing the Rack Model
Figure 9: Mounting the telescopic rails into the PRIMECENTER Rack
Ê Using the supplied Allen key (No. 5) secure the end of the telescopic rails
with the corresponding assembly brackets with two screws M4 each (1 and
2) in the rack at the support uprights and/or at the support bracket.
Note with the fact that two plugwashers each are used in the appropriate
openings of the support uprights and/or the support bracket (see figure 8 on
page 33).
Ê Adjust if necessary the length of the telescopic rails by using the oblong
holes of the assembly brackets HL and HR.
Ê Mount the PRIMECENTER Rack cable management (articulated cable
guide) as described in the Technical Manual of the PRIMECENTER Rack.
Ê Mount the server (see section "Installing the Server" on page 44).
Ê Route the cables with the inserted server as described in the technical
manual of the PRIMECENTER Rack.
34
Hardware Installation
A26361-K879-Z102-3-7619