Camera Setup - Avermedia AVerDiGi EB3004 NET User Manual

- Time Format: Select the format of time and date for the DVR system.
- Disk Overwrite: Enable/disable replacing the earliest record when the hard disk space runs out.
By default, the HDD overwrite setting is enabled
(4) Display
- VGA-TV Selection: Select the VGA and TV output order.
MAIN - MAIN: Both VGA and TV output surveillance video on screen.
MAIN – SPOT: VGA output surveillance video and TV output the alarm event video.
SPOT – MAIN: VGA output alarm event video and TV output the surveillance video.
- SPOT Mode: To select the display mode (QUAD or Channel (1, 2, 3, or 4)) on spot monitor
when there is no alarm event.
- Auto scan: Enable/disable auto cycle switch to display the next channel when in full screen
mode.
- Event Duration: Select the type of event duration.
- Set Duration: Set a time gap (10 ~ 999 seconds) before switch back to preview screen mode
after display the alarm event.
8.1.1.2

Camera Setup

(1)
(2)
(3)
(1) General
- Time Stamp
Enable/disable the time and date display on the each channel.
- Auto Record
Enable/disable auto continue recording when interrupted (i.e., power breakdown, video
playback or configuration setup). It starts to record after 10 second of idleness. This is
applicable in Always Record mode.
- Pre Record
Set the pre-recording time in seconds when alarm has occurred.
(2) Camera
Select the camera and enter a name for the camera.
(3) Color Adjustment
Select the camera and adjust the Brightness, Contrast, Hue and Saturation of the selected camera.
Click Reset to Default Value to set all video setting back to the default.
56
(4)