Alarm Setup - Avermedia AVerDiGi EB3004 NET User Manual

8.1.1.4

Alarm Setup

(1)
(2)
(3)
(4)
(1) Alarm Type
Select the way of alarming – Record, EMAIL, or RELAY.
(2) Alarm Continuously
Enable/disable to execute the alarm action (ALARM TYPE) continuously when alarm has been trigger.
The alarm action is according to the setting of ALARM TYPE that user has setup.
When ALARM CONTINUOUSLY has been started, it won't be stop until the recording has
i
been stop manually.
If ALARM CONTINUOUSLY has been enabled, the ALARM PERIOD won't be able to
configure.
(3) Alarm Period
Set the amount of time (in seconds; 0~ 999) for stop alarm action after alarm has been reset.
If ALARM CONTINUOUSLY has been enabled, the ALARM PERIOD won't be able to
i
configure.
(4) Select/Deselect ALL
To enable/disable all below selection.
i
Video Loss and HD Fail only available when the Alarm Type is Email or Relay.
- Sensor
Enable/disable to send out the alarm if sensor has been triggered according to the setting of
SENSOR SETTING.
- Motion Detection
Enable/disable to send out the alarm if motion has been detected.
To activate the motion recording, please enable the Motion Detection in this section or
i
Alarm Setting
Chapter 7.1.1.3
- Video Loss
Issue an alarm when t selected channel's video is lost.
- Remote Trigger
Allow user to trigger alarm from remote site. Click Trigger button to trigger.
- HD Fail
Issue an alarm when hard disk of DVR system is failed.
of Chapter 3.1 and configure the record mode as ALARM RECORD in
or RECORD SCHEDULE of Chapter 3.1.
60
(5)
(6)