Avermedia AVerDiGi EB3004 NET User Manual page 36

OSD MENU
EVENT SETUP
ALARM SETTING
SENSOR SETTING
MOTION DETECTION
Description
ALARM SETTING
Configure parameters of alarm.
ALARM SETUP
ALARM TYPE
ALARM CONTINUOUSLY
ALARM PERIOD
SELECT / DESELECT ALL
SENSOR
MOTION DETECTION
VIDEO LOSS
REMOTE TRIGGER
HDD FAIL
ALARM TYPE
Select the way of alarming – RECORD, EMAIL, or RELAY.
ALARM PERIOD
Set the amount of time (in seconds; 0~ 999) for stop alarm action after
alarm has been reset.
ALARM CONTINUOUSLY
Enable/disable to execute the alarm action (ALARM TYPE) continuously
when alarm has been trigger. The alarm action is according to the setting of
ALARM TYPE that user has setup.
When ALARM CONTINUOUSLY has been started, it won't be
-
i
stop until the recording has been stop manually.
If ALARM CONTINUOUSLY has been enabled, the ALARM
-
PERIOD won't be able to configure.
SELECT/DESECLECT ALL
To enable/disable all below selections.
SENSOR
Enable/disable to send out the alarm when sensor has been triggered.
MOTION DETECTION
Enable/disable to send out the alarm when motion has been detected.
To activate the motion recording, please enable the Motion
i
Detection feature here and setup record mode as ALARM RECORD
in RECORD SCHEDULE.
VIDEO LOSS
Select the channel that will send out the alarm when video is lost.
REMOTE TIRGGER
Allow user to trigger alarm from remote site.
HDD FAIL
Enable/disable to send out alarm when hard disk is failed.
31
RECORD
005 SEC
2 3 4
1