Table of Contents
Advertisement
1
Try to print!
PREPARING THE PRINTER FOR USE
Use the printer after checking the accessories (→P. 7).
Procuring the necessary materials
Before starting to print, always procure the following items:
Printer
Trash box
Paper holder
Retaining ring
Power cord
Memory card
(Sold separately)
(
SmartMedia™ (PC card))
Usable paper
Printpix Paper (Sold separately)
This printer uses roll type paper.
G Photo Type (100 mm/4 in. wide): RK-SD40
This is normal photo type paper.
Note
• Be sure that the paper retaining ring is installed.
• After use, always place the paper into the paper case.
• After using the printer, always place the paper into the paper case and store it avoiding the following locations:
- Where it is dry, where the humidity is high, or where it is dusty.
- In a vehicle in the summer, near heating equipment, and other places where the temperature is high.
- Near a window or other places where the paper will be exposed to direct sunlight or strong light.
• Paper with the protective bag unsealed cannot be stored for a long time. Use it as quickly as possible.
• Do not use paper whose effective date is expired.
• When the paper curls immediately after printing, it will flatten naturally if left alone.
• Do not drop the paper and damage the corners. It will cause the paper to jam.
10
Paper tray
Paper case
Paper
(Sold separately)
Paper end hole
G Paper
When the printer detects the
paper end holes, it judges
that there is no more paper
and does not print any
farther. Do not cut off and use
this part. It will cause paper
jamming and printer trouble.
Installing the printer
1
Install the printer.
Set the printer on a flat, wide surface.
Note
• Place the printer far enough from a wall so that the
ventilation holes are not blocked.
• When the paper is loaded, the paper compartment cover
opens upward. Therefore, provide a free space of far enough
above the printer.
2
Connect the power cord to the printer.
Connect one end of the accessory power cord to
the power input terminal on the back of the
printer.
Plug the other end of the power cord into a
power outlet.
Note
• Do not turn on the printer power yet.
3
Install the trash box and paper tray to the printer.
Note
• Always install the trash box.
• Do not turn on the printer power yet.
Note
• Do not obstruct the paper outlet or grab the paper.
Language
The language displayed on the LCD monitor can be switched among "ENGLISH", "FRENCH" and
"GERMAN". The language display setting is saved even when the printer power is turned off. (→P. 40)
1
Press the [CUSTOM] button at the top of the
printer.
After using c to select "OTHERS", use ab to
select "LANGUAGE" and press the [SET] button.
2
Use ab to select the desired language.
ENGLISH: English language display
FRENCH: French language display
GERMAN: German language display
3
When the [SET] button is pressed at the end of
setting, the monitor returns to the "OTHERS"
window.
Try to print!
1
✽ The type of power cord and
plug depends on the country.
c
Use
to select
Select
T I P
• Initial setting is "ENGLISH".
• The language display setting
is saved even when the
printer power is turned off.
11
Advertisement
Table of Contents
