Uninstalling Printer Driver - FujiFilm Printpix CX-400 Owner's Manual

12 Uninstalling the software

Uninstalling printer driver

This operation uninstall CX-400 printer driver which was installed through "FROM PRINTER DRIVER
INSTALLATION TO RESTART" procedure (P. 83).
1
Load the Printpix CD-ROM into the CD-ROM
drive.
2
Double-click "CX-400 Uninstaller" in the CD-
ROM "CX-400" folder. The message shown at
the right appears. When the [OK] button is
clicked, uninstallation is started.
3
At the end of uninstallation, the message shown
at the right appears.
Click the [Restart] button.
The Macintosh restarts.
92
Click
Click
13 Troubleshooting (Macintosh)
TROUBLESHOOTING TABLE
If the software does not operate correctly, check that you are using the correct hardware and
software (→ P. 80).
If the problem persists even though you are using the correct hardware and software, refer to the
table below and then see the reference page listed for your problem.
Type Problem
Installation problems When the printer was connected to the Macintosh,
the "Required software was not found" message or
"Required driver cannot be used" message appears.
Printer problems Pictures cannot be printed from FinePixViewer.
I want to print pictures from an application other than
FinePixViewer.
Memory card The printer is connected to the Macintosh, but the
"Removable disk" icon is not displayed.
problems
FinePixViewer does not recognize the memory card.
Mac OS "Initialize disk" message was displayed.
A warning message appears when the memory card
was removed or the USB cable was disconnected
from the printer.
The Macintosh hangs when the memory card is
accessed.
Application problems I want to quit Exif Launcher.
I want to stop FinePixViewer from launching
automatically.
I cannot log in to "FinePix Internet Service".
Internet problems
I cannot sign on as a "FinePix Internet Service" user.
I cannot update the Internet menu properly (The
buttons do not line up correctly).
94
94
94
95
95
95
96
96
96
96
97
97
97
93