Uninstalling The Software; Uninstalling Finepixviewer And Usb Mass Storage Driver - FujiFilm Printpix CX-400 Owner's Manual

8

Uninstalling the software

UNINSTALLING FinePixViewer AND USB
MASS STORAGE DRIVER
Only perform this operation when you no longer require the installed software. Turn the printer power off.
1
Quit all the currently running applications. Take particular care to shut down Exif
Launcher if it is running (→P. 78 I I want to quit Exif Launcher).
2
Close all the files.
3
Open the "My Computer" window and double-click "Add/Remove
Programs" in the Control Panel.
4
The "Add/Remove Programs Properties" window appears. Select the software to be
uninstalled (FinePixViewer or the driver) and then click the [Add/Remove] button.
Note
• Confirm that the printer power is off.
<To remove FinePixViewer>
FinePixViewer Ver.3.0
<To remove the USB Mass Storage Driver>
FUJIFILM USB Driver
5
When the confirmation message appears, click
the [OK] button. Check your selection carefully
since the process cannot be cancelled once you
click the [OK] button.
6
Automatic uninstallation begins.
When uninstallation ends, click the [OK] button.
70
Double-click
1 Select
2 Click
Click
8 Uninstalling the software
UNINSTALLING THE PRINTER DRIVER
Only perform this operation when you no longer require the installed software. Turn the printer power off.
1
Load the Printpix CD-ROM.
When the installation setup window appears,
click the [Cancel installation] button. Double-click
the "My Computer" icon, right-click the "CD-
ROM" icon and select "Open".
2
Double-click "Unin_cx.exe" in the CD-ROM
"CX400" folder.
The message shown at the right appears. Click
the [OK] button. Uninstallation begins.
3
When uninstallation is completed, the dialog box shown below appears.
<When restarting is required>
Click
Click the [Yes] button.
Click
Click
<When restarting is not required>
Click
Click the [OK] button.
71