Table of Contents
Advertisement
4
When trouble occurs
WHEN AN ERROR IS DISPLAYED ON THE LCD MONITOR
See when a window with
is displayed.
When the printer power is off and when the memory card is removed, the quantity and edit settings are cleared.
Symptom
Cause
• Paper is not loaded.
• Edge of paper is not aligned.
• Special paper is not used.
• There is a gap between the paper
holder and the paper.
• Paper is not loaded.
• Edge of paper is not aligned.
• The paper holding sticker is not peeled
off.
• Special paper is not used.
• There is a gap between the paper
holder and the paper.
Mechanism or circuits did not operate
correctly.
Paper is jammed.
• Trash box is full.
• Paper was not loaded properly.
• Paper was not ejected properly.
Trash box is full.
46
Remedy
Load the paper correctly.
• Load the Printpix Paper.
• Reload the paper so that there is no gap
between the paper holder and the paper.
• Load the paper correctly.
• Peel off the paper holding sticker.
• Load the Printpix Paper.
• Reload the paper so that there is no gap
between the paper holder and the paper.
• Unplug the power cord from the power
outlet, wait a while, and then plug the
power cord back into the power outlet and
turn on the power.
• If the printer still remains in this state,
contact your FUJIFILM dealer.
• Empty and reinstall the trash box.
• Unplug the power cord from the power
outlet, wait a while, and then plug the
power cord back into the power outlet and
turn on the power.
• Open the paper compartment cover and
wind the paper by turning the holder toward
rear with both hands.
• If the printer still remains in this state,
contact your FUJIFILM dealer.
• Empty and reinstall the trash box.
• Unplug the power cord from the power
outlet, wait a while, and then plug the
power cord back into the power outlet and
turn on the power.
• If the printer still remains in this state,
contact your FUJIFILM dealer.
Symptom
Cause
Printer ran out of paper while printing.
An error was generated because the trash
box was pulled out while printing.
Paper roll may be loose.
• Memory card is faulty.
• Memory card is not inserted fully.
The picture data to be processed is not on
the memory card.
The [EJECT] button may have been
touched while the [BUSY] lamp was
blinking.
Cleaning paper was not put in correctly.
—
When trouble occurs
4
Remedy
Load the paper correctly.
Reinstall the trash box, wait a while, and then
advance to the next picture.
• Reset the paper so there is no gap
between the paper holder and the paper.
• Open the paper compartment cover and
tighten the paper on the roll and reload the
paper.
• If the printer still remains in this state,
contact your FUJIFILM dealer.
• Remove the memory card and reinsert it
until it clicks.
• Do not touch the [EJECT] button while the
[BUSY] lamp is lit or blinking.
There are no displayable pictures. Check the
contents of the memory card.
• Do not touch the [EJECT] button while the
[BUSY] lamp is lit or blinking.
• Use the [SET] button to start operation.
Open the paper compartment cover and put
in the cleaning paper correctly.
Load Printpix paper and close the paper
compartment cover.
47
Advertisement
Table of Contents
